First day, first problems…
Spent the whole Sunday covered in grease; disassembling the rear axle. The start was pretty much ok, got the lower wishbones loose pretty easily. The only somewhat interesting part was getting the bearings out. Two sockets of appropriate size and a vice:
and out they come in no time:
I wish i could say the same for getting the universal joints out of the drive shafts. I already had them soaked with WD40 since the day before. They were all so tight that the vice handle had to be lengthened with a meter of steel pipe and my full weight applied to that (which is a good 10 kilo’s more than it used to be since i stopped smoking). When the day was over, i managed to get 2 universal joints removed. The first was relatively easy (took me only 2 ½ hours). The second was worse and its removal damaged one of the shafts:
Apparently the thing was so tight it scraped some of the metal into a rim. Obviously, that has to be removed again later on, hmm will that be a problem on reassembly?
I’m still suppressing thoughts on the remaining two joints….
Please use your old worn & torn jeans in the future, you greasy filthy guy!!!
X
Als oom trots op neef zijn, haug Geert
Ben trots op oe.
Dat je dit aangaat.
Geert
[...] the rear driveshafts with the universal joints is an easy job (unlike the disassembly of them). Especially using my press, getting in the Universal Joints is very easy to do and the [...]
[...] of the parts showed a worn (broken ?) inner wall. The other shaft had problems too but those I managed to repair to satisfaction. This one will have to be [...]